365速发

Product features

• ▪ User friendly 7” color touch panel display
  
• ▪ Support multi-language & facilitate users
  
• ▪ Built-in environment self-test program
  
• ▪ Programmable operation
  
• ▪ Pre-programmed IEC standard test levels, easy to operate
  
• ▪ RS232/USB interface, PC control operation & printable test report
  
• ▪

Product parameters

• Model
  

  Power supply voltage
  

  CDN (coupling/decoupling network)
  

  Duration
  

  Interval
  

  Number of tests
  

  Power supply
  

  Ambient temperature
  

• VDT DC
  

  1~80V (customer specific on demand)
  

  DC 20A
  

  1ms~9999ms
  

  0.1~999.9s
  

  1~9999
  

  AC220V 50/60Hz
  

  15℃~35℃
  

Product recommendation

Single Phase 20A Voltage Dips Generator

Model：VDT S20

Voltage dips/sags, short interruptions are caused by failures of the power grid and power facilities or sudden large changes in loads. In some cases, there will be two or more consecutive dips or interruptions. Voltage changes are caused by continuous changes in the loads connected to the grid. If the EUT cannot respond in time to changes in the power supply voltage, it may cause malfunctions. Voltage dips generators are used to evalsuate the performance of electrical and electronic equipment when subjected to voltage dips/sags, short interruptions, and voltage changes. Products fully meet the requirements of standards IEC/EN 61000-4-11 and GB/T17626.11.

Learn more

Impulse current generator sur 6ka

Model：SUR 6KA

The lightning surge generator sur 6ka is used to inspect the anti surge protection devices such as zinc oxide arrester valve piece, varistor, SPD, TVs tube, gas discharge tube, etc. for surge impact test. The product produces 8/20us surge pulse waveform, and the technical indicators of the waveform comply with the provisions of national standards and IEC standards.

Learn more

On board electronic transient interference simulator RV p1p2a

Model：RV P1P2a

P1 is the transient phenomenon generated when the analog power supply is disconnected from the inductive load. It is applicable to the situation that various DUTs are directly connected in parallel with the inductive load when they are used on the vehicle; P2a simulates the transient phenomenon caused by the sudden interruption of the current in the device in parallel with the DUT due to the inductance of the harness. The on-board electronic transient interference simulator RV p1p2a meets the latest requirements of iso-7637-2 and gb/t21437.

Learn more